On this page
A safe exposure time depends on two numbers: the level in dBA and how long you hear it. The NIOSH recommended exposure limit (REL) is 85 dBA for 8 hours, with a 3 dB exchange rate: every 3 dB increase halves the allowed time. The OSHA permissible exposure limit (PEL), the legal limit for most US workplaces, is 90 dBA for 8 hours with a 5 dB exchange rate. NIOSH is the more protective of the two, and it is the one to use for your own hearing.
The quick rule
Start at 85 dBA and 8 hours. Add 3 dB, halve the time:
- 85 dBA: 8 hours
- 88 dBA: 4 hours
- 91 dBA: 2 hours
- 94 dBA: 1 hour
- 97 dBA: 30 minutes
- 100 dBA: 15 minutes
- 103 dBA: 7.5 minutes
- 106 dBA: under 4 minutes
The time is a daily total, and it assumes the rest of your day is quieter than about 80 dBA. Quiet time afterwards doesn’t “cancel” loud time.
Full table: NIOSH vs OSHA, 85 to 115 dBA
Maximum daily exposure at each level, calculated from each agency’s formula (T = 8 h ÷ 2^((L − criterion) ÷ exchange rate)). Times are rounded.
| Level | NIOSH REL (85 dBA, 3 dB) | OSHA PEL (90 dBA, 5 dB) |
|---|---|---|
| 85 dBA | 8 h | 16 h |
| 86 dBA | 6 h 21 min | 13 h 56 min |
| 87 dBA | 5 h 2 min | 12 h 8 min |
| 88 dBA | 4 h | 10 h 33 min |
| 89 dBA | 3 h 10 min | 9 h 11 min |
| 90 dBA | 2 h 31 min | 8 h |
| 91 dBA | 2 h | 6 h 58 min |
| 92 dBA | 1 h 35 min | 6 h 4 min |
| 93 dBA | 1 h 16 min | 5 h 17 min |
| 94 dBA | 1 h | 4 h 36 min |
| 95 dBA | 48 min | 4 h |
| 96 dBA | 38 min | 3 h 29 min |
| 97 dBA | 30 min | 3 h 2 min |
| 98 dBA | 24 min | 2 h 38 min |
| 99 dBA | 19 min | 2 h 18 min |
| 100 dBA | 15 min | 2 h |
| 101 dBA | 12 min | 1 h 44 min |
| 102 dBA | 9.4 min | 1 h 31 min |
| 103 dBA | 7.5 min | 1 h 19 min |
| 104 dBA | 6 min | 1 h 9 min |
| 105 dBA | 4.7 min | 1 h |
| 106 dBA | 3.8 min | 52 min |
| 107 dBA | 3 min | 45 min |
| 108 dBA | 2.4 min | 40 min |
| 109 dBA | 1.9 min | 34 min |
| 110 dBA | 1.5 min | 30 min |
| 111 dBA | 1.2 min | 26 min |
| 112 dBA | 56 s | 23 min |
| 113 dBA | 45 s | 20 min |
| 114 dBA | 35 s | 17 min |
| 115 dBA | 28 s | 15 min |
OSHA does not allow exposure to continuous noise above 115 dBA at all, however short. For your own planning, read the NIOSH column. For typical sources at each level, see the decibel chart.
Peak levels: the 140 dB ceiling
The table covers steady or fluctuating noise averaged over time. Very short, very loud bangs are treated separately. Both NIOSH and OSHA set a ceiling of 140 dB peak for impulse or impact noise, such as a gunshot, a nail gun next to your ear or fireworks at close range. Above that, there is no “safe time”: a single event can cause permanent damage.
A phone can’t measure this reliably. Phone microphones and their software usually clip well below 140 dB, and peak measurement needs a meter with a proper peak detector. If you work around impulse noise, wear protection whatever your phone says.
Why NIOSH is stricter than OSHA
The two limits come from different eras and different goals.
The criterion level
OSHA’s 90 dBA limit was adopted in the early 1970s, carried over from an earlier rule for federal contractors, and has not been lowered since. NIOSH reviewed the evidence in its 1998 criteria document and estimated that over a 40-year working life, the excess risk of material hearing impairment is about 8% at 85 dBA and about 25% at 90 dBA. That is why NIOSH recommends 85 dBA. Even at 85 dBA the risk isn’t zero.
The exchange rate
The bigger difference is the exchange rate. A 3 dB step follows the equal-energy rule: 3 dB more means twice the sound energy, so half the time gives the same energy dose. OSHA’s 5 dB step assumed that breaks in noisy work let the ear recover, which later research did not support. The effect grows with level: at 100 dBA OSHA allows 2 hours, NIOSH 15 minutes, an eightfold difference. The 3 dB rule is also what ISO 1999, the EU and the UK use.
Working it out for a mixed day
Real days aren’t one steady level. Maybe 2 hours at 88 dBA in a workshop and 30 minutes at 97 dBA with a grinder. Each piece uses up a share of your daily allowance: 2 of 4 hours is 50%, 30 of 30 minutes is another 100%, so that day is at 150%. That share is your noise dose. The guide noise dose and TWA walks through the maths, or let the noise exposure calculator do it for you.
How to use these times in real life
- Measure, don’t guess. People are bad at judging levels by ear. Open the online sound meter where you spend the time and note the average (Leq), not the quick peaks.
- Allow for phone error. A calibrated phone is typically within a few dB, and less accurate above about 100 dB. Because 3 dB halves the time, a reading of 91 dBA could really mean 1 to 4 hours. Round towards caution. See calibrating a phone sound meter.
- Protection changes the number that counts. What matters is the level at your eardrum. Good earplugs or earmuffs can bring a 100 dBA environment down into the 80s if they fit well. Hearing protection ratings explains how much to trust the label.
- Ringing ears means you went over. Tinnitus or muffled hearing after noise is a sign of temporary damage, even if it fades by the next day.
These figures are for general guidance, not medical advice. If you notice changes in your hearing, see an audiologist or doctor.
Frequently asked questions
How long can you be exposed to 100 dB?
About 15 minutes a day under the NIOSH recommended limit. OSHA’s legal limit for US workplaces allows 2 hours at 100 dBA, but NIOSH’s figure is the safer one to plan around.
Is 85 dB safe for 8 hours?
85 dBA for 8 hours is the NIOSH recommended limit, which equals a 100% daily noise dose. It is a limit, not a safe target: NIOSH still estimates a small excess risk of hearing loss over a working lifetime at that level. Staying below it, or wearing hearing protection, is better.
How long is safe at 90 dB?
About 2.5 hours a day using NIOSH’s 3 dB exchange rate. OSHA permits 8 hours at 90 dBA, but that limit is older and less protective.
Does the time have to be continuous?
No. The limits are for the total time in a day. Twenty minutes at a loud venue plus forty minutes with power tools counts as an hour at that level. When levels vary across the day, add up the pieces as a noise dose.
What noise level causes instant damage?
Both NIOSH and OSHA say no one should be exposed to impulse peaks above 140 dB, such as gunshots or explosions at close range. Even a single exposure at that level can cause permanent damage.